03 Dec How to put floor tiles – instructions, useful tips
Ceramics tiles are considered one of the very pretty coatings for the floor for the bath, kitchen and other rooms. How to lay tiles for the floor evenly, without leaning to the services of professionals, this article will tell. The process of laying tiles on the floor consists of several stages.
The floor is leveling
It includes the removal of the coating that is already outdated, the primer mixture, the hipping of hydro-insulation, and leveling. Removing the coating that is already outdated in most cases does not cause difficulties. After cleaning the floor, the rectification queue comes. The main thing! Do not neglect the primer, as many companies do it. The overwhelming part of the primer has an antiseptic in its own composition and makes it possible to save on the material which will be used in subsequent points of laying tiles. The primitive mixture should be applied twice. Hydraulic protection – no less significant moment in the preparation of the floor for laying the coating. It is necessary to eliminate the appearance of mold and fungi under the basis of the floor. Floor leveling is done using a finished mixture and spatula with teeth. The floor in a large room can be aligned in 2 cycles, dividing the surface into squares. Example: 1 day squares are aligned from one edge, the next – from the other. It is important to know: Basically, the mixture for alignment instantly hardens, and therefore it is recommended to dilute it with water in small doses.
Preparation of components
Laying tiles for the floor asks not only the stay of the mother itself, but also the necessary tools. These include:
– glue-cement for laying mothers;
– tile cutter;
– spatula with teeth;
– crosses (dividers);
– pencil;
– rubber spatula;
– spirit level;
– roulette;
– ticks to bite off Matryal;
– Maular cord (or ordinary chalk) for flooring;
– Grout for seams.
The main thing! The structure of the floor tiles makes it possible to visually increase or decrease the room. For small rooms, bright components are recommended without bulges, the mosaic structure can be used for the floor in the rooms, in which resistance, for example, is needed in the bathroom room. When everything is prepared for the creation of a new flooring for the floor (dry, perfect and clean floor, all the material and the necessary tools in the required quantity) must be determined with the laying options.
Variations of laying tiles for the floor
You can lie it with several options:
– straight rows. Tiles for such laying must be approximately the same size;
– “In a run” – the parts of the coating in any next row are placed so that their middle is above the inter -seam of the underlying row;
– Diagonally: the angle of the tile rests against the wall, plus it lies in the same way as in other cases, close to each other.
Whatever option to be chosen, its process boils down to the main actions:
Paul deployment. It is worth immediately set the number of tiles and their placement. You can lay the coating from the center or start from some wall. Again, you can find the middle of the room: combine the lines from indoor corners with a chalk. As a result, a cross will be released, tearing the room on the 4th segment. Symmetry can be achieved if you lay the tile, in turn filling each part of the room.
The main thing! Near the entrance and along the far wall it is recommended to lay a holistic tile; Glue touches. The most beautiful thing is to apply it specifically to the floor, aligning with a spatula with teeth. Glue is applied about 1 m? floor;
– Laying tiles. You need to lay it with a light press. The distance between the tiles is regulated using separators (crosses).
Grouting seams of tiles for the floor. Grout rubs into the seams using a rubber spatula. The remains of the grout from the plane are removed with wet cloth.
The main thing! Experts recommend using the floor and use it a day after laying the flooring for the floor.
Video: how to lay floor tiles
No Comments